W-244 Computer-Controlled Pipecutter

With Four-Axis Control for controlled bevels and deep weld penetration

This is the latest four-axis pipe cutting machine from Watts Specialties, Inc. The W-244 is controlled by a heavy-duty industrial computer designed to run in extremes of temperature, humidity and vibration. All controls are remotely mounted at the cutting head for easy access. The W-244 uses the latest computer motion-control systems along with an innovative floating headstock and cutting head design. Only a floating headstock and cutting head allows smooth accurate handling of irregular pipe that could cause erratic cutting with a typical headstock.

This easily programmable system is accurate, reliable, easy to maintain and easy to operate. With this machine you can cut any contoured pipe-end in minutes. By using the simple computer menu you can also set up saddle holes, slots, rectangles or other custom cuts.

Cutting shapes can include T’s, full Y’s, K’s, straight cuts, miters, 90 degree saddles, mitered saddles (laterals), off-set saddles, holes, saddle holes, mitered saddle holes, slots, rectangles, and crosses. Intersections of four pipes or more can be set up in minutes.

See custom structural cuts here.

All of these cuts can be set up with minimal training and are easily repeated later. Once a pipe is set up with multiple operations the entire job can be saved on the rugged flash memory card for recall later. Literally thousands of patterns can be stored on the machine. Optional network connections are also available. Multiple holes and cuts are made in perfect dimensional relationship to one another. You can also reload a partial job and retrace the steps back to where you left off.

Unlike most mechanical systems, the torch cutting speed remains constant even on steep angles. This computer precision assures fast cutting speeds and a smooth cut. Piercing is done off the cutting line for a clean edge. The unique drive system is based on a gimbaled clamping system which floats vertically and horizontally. This provides smooth positive rotation even with badly out-of-round or curved pipes. This system also prevents the pipe from walking lengthwise away from the drive clamp. This system is superior to fixed chuck drive systems which can be erratic when driving an oval pipe against the carriage wheels. The W-244 cutting head also floats mechanically on the pipe surface for accurate torch tip standoff control.

When you buy a W-244 you can be assured you will easily triple or quadruple shop production compared to hand-cut pipe. You can also count on great customer support and service from one of the oldest pipe cutting equipment suppliers in the business.

Watts Specialties, Inc.

Contact us at 253-848-9288

>Email Watts Specialties here